Nautilus BE STRONG NS 75X - Manual (Page 14)

1
Step 6 Components:
Procedure:
ASSEmBLY
STEP 6
# component Qty
25 Leg Press Cable w/ Termination 1
26 3 1/2” Pulley 4
27 4 1/2” Pulley 3
34 Hex Bolt - 3/8” x 2 3/4”L 4
35 Hex Bolt - 3/8” x 2”L 3
37 Hex Bolt - 3/8” x 1”L 1
40 3/8” Flat Washer 6
43 3/8” Lock Nut 8
44 Step Spacer 8
a. Attach the looped end of the Leg Press Cable (25) to the cable bracket
located on the Seat Back Support Assembly using the hardware
shown above.
B. Place two 3 1/2” Pulleys in the Seat Back Support Assembly using the
hardware shown above. Pass the Leg Press Cable over the pulleys
and slide the cable through the Seat Tube Assembly out the front.
c. Run the cable over the 3 1/2” Pulleys and attach them to the Seat
Tube Assembly using the hardware shown.
D. Attach a 4 1/2” Pulley to the Leg Press Power Arm using the hardware
shown above. Pass the cable over the top of the pulley and then over
the top of the lower 3 1/2” pulley in step C.
e. Wrap the cable around a 4 1/2” Pulley and secure in place using the
hardware shown and the L Cable Retainer (6) to the Angled Pulley
Bracket (7).
F. Connect the Leg Press Cable Termination to the Gym Cable.
G. Adjust the cable tension using the adjustments located on the gym.
H. Attach leg press handles as shown in Step #2.
3/8" x 1"L
3/8" x 2 3/4"L
3/8" x 2"L
3/8" x 2 3/4"L
3/8" x 2"L
3/8" x 2"L
25
25
34
34
34
34
26
26
35
35
35
43
27
NOT USED ON THE
NS700X
40
37
27
6
44
43