NEC 1160Xd - Manual (Page 16)

12 Express5800/1160Xd/1320Xd Installation Procedures
Attaching the Power Cables
1. Open the rear door of the server and remove any shipping tape.
2. Route the AC cables (customer supplied) under the server and connect them
to the AC receptacles. See Figure 12A.
A
A AC Receptacles
Figure 12. Attaching the Power Cables
Attaching the LAN Cables
1. Open the front door of the server. Locate the service processor boards (see
Figures 13A and 14A).
2. Connect the LAN cables to the ETHER connector on the service processor
boards (see Figure 15).
3. Remove the screws securing the open channel cover and remove the cover
(see Figures 13B and 14B).
4. Carefully route the LAN cables along the left side of the cabinet and through
the open channel to the rear of the server. Use the cable ties at the rear of the
server to secure the cables. Route the cables to the left side of the server and
down under the cabinet frame.
5. Replace the open channel cover on the front of the server and secure it with
the screws.