NordicTrack TRL 625 831.298961 - Manual (Page 8)

8
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (refer to
page 11), follow the steps below to install the receiver and
the short jumper wire included with the chest pulse sensor.
1. Remove the four indicated screws from the back of the
Console (3). Lift the top of the Console. Be careful not
to disconnect any wires.
2. Peel the paper off the adhesive pad on the back of the
receiver (A). Orient the receiver as shown, and press it
onto the Console (3) in the indicated location.
Connect the wire on the receiver (A) to the short
jumper wire (B) as shown. Plug the other end of the
short jumper wire into the indicated jack (C).
Refer to step 1 above. Reattach the top of the Console
(3) with the four screws. Make sure that no wires are
pinched.
Note: Any other wires that are included with the chest
pulse sensor may be discarded.
3
Screws
1
C
2
3
B
A