Assembly – NordicTrack NTBE01700 User Manual

Page 6

Before beginning assembly, carefully read the
following information and instructions:

• Assembly requires two people.

• Place all parts in a cleared area and remove the

packing materials. Do not dispose of the packing
materials until assembly is completed.

• Tighten all parts as you assemble them, unless

instructed to do otherwise.

• As you assemble the weight bench, make sure all

parts are oriented as shown in the drawings.

• For help identifying small parts, use the PART

IDENTIFICATION CHART on page 5.

The following tools (not included) are required
for assembly:

• Two adjustable wrenches

• One rubber mallet

• One standard screwdriver

• One Phillips screwdriver

• Lubricant, such as grease or petroleum jelly,

and soapy water.

Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.

Assembly

Make Things Easier for Yourself!

Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by anyone. However, it is important to
realize that the versatile weight bench has many
parts and that the assembly process will take
time. Most people find that by setting aside plen-
ty of time, assembly will go smoothly.

1. Press a 3” x 2” Outer Cap (10) onto each end of the

Stabilizer (13).

Attach the Stabilizer (13) to the Bench Frame (5)
with two 3/8” x 2 3/4” Button Head Bolts (12) and
two 3/8” Nylon Locknuts (11). Note: There is an
indentation around the holes on one side of the
Stabilizer. This side must be facing the floor so
that the warning decal is in the position shown.

Note: Do not tighten the Nylon Locknuts yet.

2. Press a 2” Square Outer Cap (20) onto each end of

the Bench Base (7).

Attach the Bench Base Joint Plate (19) to the Bench
Base (7) with two 3/8” x 3” Bolts (21), two 3/8”
Washers (6), and two 3/8” Nylon Locknuts (11).

Attach the Bench Leg (1) to the Bench Base Joint
Plate (19) with two 3/8” x 3” Bolts (21), two 3/8”
Washers (6), and two 3/8” Nylon Locknuts (11).

Be sure the welded nut is in the position shown.

Note: Do not tighten the Nylon Locknuts yet.

Decal

Welded Nut