NuTone QTREN080 - Manual (Page 4)

MODELS QTREN080 • QTREN110
Page
TAB
SERVICE PARTS
99043799E
INSTALL GRILLE
6. Attach grille
to housing.
Squeeze grille
springs and insert
them into slots on
each side of hous-
ing.
7. Push grille
against ceil-
ing.
5. Finish ceiling.
Install ceiling material. Cut out around housing.
4. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use
proper UL approved connector to secure house wiring to
wiring plate. Connect wires as shown in wiring diagrams.
CONNECT WIRING
Order service parts by “Part No.” - not by “Key No.”
* Not shown assembled.
SERVICE NOTE To remove Blower Assembly: Unplug motor (7). Remove
thumbscrew (16) from motor plate (9) flange. Find the single TAB on the motor plate (located
next to the receptacle). Push up near motor plate tab while pushing out on side of housing.
or insert a straight-blade screwdriver into slot in housing (next to tab) and twist screwdriver.
Replacement parts
can be ordered on our
website. Please visit us
at www.nutone.com
Key No. Part No. Description
1 97016466 Housing
2 97016449 Duct Connector-4”
3 98010102 Wiring Plate
4 99170245 Screw, #8-18 X .375
5 97016932 Wire Panel/Harness Assembly
6 99020284 Blower Wheel
7 99080580 Motor
8 99100491 Isolator (4 req’d)
9 97016468 Motor Plate
10 99250959 washer #8 (4 req’d)
11 99260558 Nut, Hex lock #8-32 (4 req’d)
* 97016738 Blower Assembly
(includes key nos. 6 thru 11)
12 97016610 Grille Assembly
(includes key no. 13)
97016915 Grille Assembly - Microban
(includes key no. 13)
13 99140199 Grille Spring (2 req’d)
14 99111293 Spacer (2 supplied)
15 QTNHB1 Hanger Bar Kit
16 99420665 Thumbscrew, #8-18 x .375