NEC XM37 - Manual (Page 13)

13
16
15
Battery Installation and Replacement
The remote control is powered by two 1.5V AA batteries.
Remote Control Cautions
• Do not drop or mishandle the remote control unit.
• Do not get the remote control unit wet. If the remote gets wet, wipe it dry
immediately.
• Avoid heat and humidity.
• When not using the remote control unit for a long period, remove the
batteries.
• Do not use new and old batteries together, or use different types of batteries
together.
• Do not take apart the batteries, heat them, or throw them into a fire.
Operating Range
• The infrared signal operates by line-of-sight up to a distance of
approximately 22 feet/7 m and within a 60 degree angle of the remote
sensor of the monitor.
• The monitor will not function if there are objects between the remote control
and the sensor or if strong light falls on the sensor. Weak batteries will also
prevent the remote control from properly operating the monitor.
3. Close the battery compartment cover. 1. Turn the remote control unit upside
down. Press down on the battery
compartment grip and slide the
compartment in the direction of the
arrow.
2. Install the two new batteries, making
sure that their polarity matches the (+)
(-) diagrams inside the battery
compartment. Incorrect polarity could
damage the remote control unit.
POWER STANDBY
/POWER
79644641
POWER ON
RGB 2 RGB 1 VIDEO 2 VIDEO 1
POSITION / CONTROL PROCEED
EXIT
SCAN
NORMAL SIDE PIN HEIGHT WIDTH
BRIGHT CONTRAST MUTE
NORMAL
VOLUME
OFF DEGAUSS
MULTIMEDIA MONITOR
RD-346E
30 30