NEC VXi User Manual
Page 96
Using the System Drives and Bays 5-7
6.
Align the notch with the notch in the slot connector and install the module as
follows:
!
Hold the SO-DIMM at a 60-degree angle and align the SO-DIMM connector
with the slot in the system. Push the connector into the slot.
!
Press down on the edge of the SO-DIMM until the locking tabs on the sides
snap into place, securing the module.
Installing the memory module
7.
To remove a SO-DIMM, press the locking tabs away from the sides of the module
until the module pops up. Then, remove the SO-DIMM.
Removing the memory module