Napoleon Fireplaces NZ26 - Manual (Page 11)

W415-0156 / B / 10.31.05
11
TOP FLAME SPREADER
BOTTOM FLAME SPREADER
FIBRE BAFFLES
TOP FIBREBRICKS
TUBE BURNERS
GASKET
LEFT SIDE FIBREBRICK RIGHT SIDE FIBREBRICK REAR FIBREBRICKS
GASKET
RIGHT FRONT FIBREBRICK LEFT FRONT FIBREBRICK
BOTTOM RIGHT FIBREBRICK BOTTOM LEFT FIBREBRICK
BAFFLE SUPPORT
Insert the left baffle, then the left top firebrick. Repeat
using the right baffle and brick.
The baffles are made of a brittle material. Care must be
taken not to bend or force them.
Replace the three front tubes. Position the center edges of
both baffles and bricks until they lie snugly together.
Slide the baffle support bracket into place along the front of
the unit between the front tube and the two top firebricks.
Place gasket rope along the upper ledge of the air
chamber and on the top of the rear bricks. The top
and bottom flame spreaders come taped together. This
tape will burn away in the initial firing of the unit. On subse-
quent brick removals, the bottom flame spreader must be
taped to the top spreader to ease top brick and baffle re-
moval and to avoid damaging the fibre baffles.
WARNING: Operation of the fireplace without the top
firebricks and the baffles can result in excessive tem-
peratures that could damage the fireplace, chimney
and the surrounding enclosure.
1
1
2
3
GASKET ROPE LOCATION
2
R E A R
BRICKS
4
Unscrew and remove the front tube retainer. Note that
the first tube retainer also holds the side brick in place.
Slide the tube either to the left or right and remove. Remove
the two middle tubes in the same fashion.
The fireplace is shipped with the firebricks in place. Top
firebricks, fibre baffles and gasket rope are not installed.
FIGURE 21
FIGURE 23
FIGURE 22
TOP FLAME SPREADER
BOTTOM FLAME SPREADER
FIBRE BAFFLE (1 OF 2 SHOWN)
TOP FIREBRICK (1 OF 2 SHOWN)
3a
3b
BAFFLE SUPPORT BRACKET
TOP FIREBRICK AND BAFFLE
INSTALLATION:
1
FIBRE BAFFLE
TUBE
TOP FIREBRICK
TUBE
RETAINER
FIGURE 20