Napoleon Grills MIRAGE 730 - Manual (Page 18)

18
TWO PEOPLE ARE REQUIRED
FOR THIS STEP
6 x
N570-0073 (1/4-20 x 3/8”)
3/8
10 Grill Head Installation
PROPANE ONLY - To avoid assembly difficulties, prior to mounting the grill
head, remove zip tie holding regulator up under control panel. This was installed
at the factory to protect the regulator hose during shipping and is no longer re-
quired. (Take care when removing the tie not to damage the hose).
Lift grill head and place on assembled cart, lining up holes in top of side cart
panels with holes in bottom of base. Fasten from inside using (4)1/4-20 x 3/
8”screws, two per side. Install battery pack below vent slots on left hand panel
using double sided tape supplied with battery pack. Plug wire from LED (lights)
located underneath control panel into wire from battery pack. Install rotisserie
mount bracket to left side of barbecue as shown using (2) 1/4-20 x 3/8” screws.