Napoleon Grills BIPRO 450 - Manual (Page 21)

21
www.napoleongrills.com
BIPRO450 BUILT-IN INSTRUCTIONS
N570-0086
N080-0213
N715-0080
N570-0086 N080-0213
W445-0031
N010-0281
N010-0568
3/8”(10mm)
4 x N570-0086 (#14 X1/2”)
This grill is designed for masonry, NON-COMBUSTIBLE enclosures only, and must be installed and serviced by a qualified
installer to local codes.
1. Attach side mounting brackets to each side of the grill using #14 x 1/2" screws (N570-0086).
2. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied to each wing of
the rear trim.
3. Lower the unit in place, the wings on the rear trim should be under the side mounting brackets. Connect the flex supply line
to the fitting at the end of the manifold.
4. The entire installation must be leak tested before operating the unit.