Nokia HS-3W - Manual (Page 8)

G e t t i n g s t a r t e d
8
■ Removing and installing the battery
Note: Before changing the cover, always switch off the power
and disconnect the device from the charger. Always store and
use the device with the covers attached.
The headset has a rechargeable Li-Polymer battery.
• Open the battery cover by gently pushing the release button and
sliding the battery cover backwards, see Figure 2.1.
• Remove the battery, see Figure 2.2.
• Detach the connector from its space and detach the battery from the
connector, see Figure 2.3.
• Replace the battery. Place the connector in the space reserved for it
and set the battery in place, see Figure 2.4.
• Close the battery cover, see Figure 2.5.
• Make sure that the cover is properly locked in place, see Figure 2.6.
hs-3W_en_1st_tab.fm Page 8 Tuesday, December 16, 2003 10:31 AM