Napco Security Technologies GEM-K1CA - Manual (Page 29)

29
K E Y P AD M E S S AG E S
The system is in the process of reporting a cancel signal to central station which will
cancel the alarm which it has just reported.
The alarm signal has been cancelled during the Abort Delay (before an alarm signal
report was sent to the central station). If cancelled after the alarm signal report was
sent, this message appears when the system receives an acknowledgment from the
central station of the cancellation of the alarm signal.
Indicates problem(s) detected on system. (See examples below and SYSTEM
TROUBLE ERROR CODES for a complete list of system troubles and corrective
actions.)
Check power transformer. Check for blown fuse or circuit breaker; general power
outage.
Battery weak. If not recharged within 24 hours, replace battery.
Communication failure to central station.
A T T E M P T I N G T O
C A N C E L
A L A R M C A N C E L E D
* * S Y S T E M T R B L * *
L O W B A T T E R Y
E 0 2 - 0 0 S E R V I C E
C O M M F A I L
E 0 3 - 0 0 S E R V I C E
A C P O W E R F A I L
E 0 1 - 0 0 S E R V I C E