Network Technologies NTI UNIMUX UNIMUX-USBV-2 - Manual (Page 4)

NTI UNIMUX 2-PORT USB KVM SWITCH
1
INTRODUCTION
The UNIMUX-USBV-2 (formerly referred to as KEEMUX-USBV-2U) USB KVM switch allows one user to access two USB CPUs
with only one USB keyboard, USB mouse, and 15HD VGA monitor. Internal microprocessors allow both CPUs to boot
simultaneously and error-free. Port selection is accomplished by a front panel push button or commands typed on the keyboard.
Types of User Input Devices Supported:
•
USB keyboard with Windows
®
layout
• USB keyboard with SUN layout
• USB keyboard with MAC layout with mouse
• USB Mouse - (up to 3 buttons)
• USB IntelliMouse
®
(scrollwheel)
• NTI USB-Sun Adapter
• USB Hub
• Microsoft, Logitech, and Kensington mice/trackballs
Types of CPUs Supported:
Any USB CPU supporting USB version 1.0 or above including:
• USB
WINxx
• USB MAC
• USB SUN
NOTE: UNIMUX-USBV-2 is fully compliant with USB standards (1.0, 1.1)
MATERIALS
Materials Supplied with this kit:
•
NTI UNIMUX-USBV-2U USB KVM Switch
• 120V at 60Hz-5VDC/0.5A AC Adapter (Domestic Only) OR 120/240V at 50/60Hz -5VDC/2.0A AC Adapter (Foreign or
Domestic)
• Line Cord, country specific (only supplied when 120/240V AC adapter is supplied)
Materials Not Supplied, BUT REQUIRED:
A set of 2 cables for each USB CPU being connected to the switch must be used:
• VEXT-xx-MM for monitor interface
• USB-AB-xM for device (keyboard and mouse) interface.
Legend:
xx is the length of the cable in feet
M is an abbreviation for meters
MM indicates male-to-male connector
Cables can be purchased from Network Technologies Inc by calling (800) 742-8324 (800-RGB-TECH) in the US and Canada or
(330) 562-7070 (worldwide).