NISSAN 2009 Quest - Manual (Page 37)

Fastening the seat belts
1. Adjust the seat. See “Seats” earlier in this
section.
᭺
2 Slowly pull the seat belt out of the retractor
and insert the tongue into the buckle until
you hear and feel the latch engage.
● The retractor is designed to lock during
a sudden stop or on impact. A slow
pulling motion permits the seat belt to
move and allows you some freedom of
movement in the seat.
● If the seat belt cannot be pulled from
its fully retracted position, firmly pull
the belt and release it. Then smoothly
pull the belt out of the retractor.
᭺
3 Position the lap belt portion low and snug
on the hips as shown.
᭺
4 Pull the shoulder belt portion toward the
retractor to take up extra slack. Be sure the
shoulder belt is routed over your shoulder
and across your chest.
The front passenger seat, 2nd row captain’s
chairs and the rear bench seat three-point seat
belts have two modes of operation:
● Emergency Locking Retractor (ELR)
● Automatic Locking Retractor (ALR)
Manual front seat shown
WRS0520 WRS0137 WRS0138
Safety—Seats, seat belts and supplemental restraint system 1-21
੬
REVIEW COPY— 2009 Quest (van)
Owners Manual—USA_English (nna)
07/17/08—debbie
੭