Nokia 9362065 - Manual (Page 32)

Copyright © 2003 Nokia. All rights reserved. 32
Mute or Unmute , End active call , End all calls , Hold or Unhold , New call ,
Conference , Private , Drop participant , Answer , and Reject .
Swap is used to switch between the active call and the call on hold.
Transfer is used to connect an incoming call or a call on hold with an active call
and to disconnect yourself from both calls.
Send DTMF is used to send DTMF tone sequences, for example, passwords or bank
account numbers.
Note: You may not have all of these options. Contact your service provider
for more details.
1. Key in the digits with - . Each keystroke generates a DTMF tone,
which is transmitted while the call is active. Press repeatedly to produce:
*, p (inserts a pause of approximately two seconds before, or between DTMF
characters.), and w (if you use this character, the remaining sequence is not
sent until you press
Send again during the call). Press to produce #.
2. To send the tone, press OK .
Call waiting (network service)
If you have activated the Call waiting service, the network will notify you of a new
incoming call while you have a call in progress.
1. During a call, press to answer the waiting call. The first call is put on hold.
To switch between the two calls, press Swap .
2. To end the active call, press .