Nikon PD-10 User Manual

Page 4

This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful in-
terference, and (2) this device must accept any interference received, in-
cluding interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to oper-
ate this equipment.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and op-
erated with minimum distance 20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.

Nikon Corporation declares that the Wireless Printer Adapter
PD-10 ( FCC ID: MXF-U940829G) is limited in CH1~CH11 for 2.4 GHz
by specified firmware controlled in U.S.A.

Notice for customers in the State of California

WARNING: Handling the cord on this product will expose you to lead, a
chemical known to the State of California to cause birth defects or other
reproductive harm. Wash hands after handling.
Nikon Inc.,
1300 Walt Whitman Road, Melville, New York
11747-3064, U.S.A.
Tel.: 631-547-4200

Notice for customers in Canada

CAUTION

This class B digital apparatus meets all requirements of the Canadian In-
terference Causing Equipment Regulations.
RSS-210 14. Exposure of Humans to RF Fields
The installer of this radio equipment must ensure that the antenna is lo-
cated or pointed such that it does not emit RF field in excess of Health
Canada limits for the general population; consult Safety Code 6, obtain-
able from Health Canada’s website:

www.hc-sc.gc.ca/rpb

ATTENTION

Cet appareil numéique de la classe B respecte toutes les exigences du Rè-
glement sur le matériel brouilleur du Canada.

IC statement

Operation is subject to the following two conditions:
1) This device may not cause interference and
2) This device must accept any interference, including interference that

may cause undesired operation of the device.