Nikon PD-10 - Manual (Page 15)

9
En
LED Lamp Display
The POWER, LINK and BUSY lamps (c3) indicate the following after the printer and camera are set up.
During printing standby, each lamp displays the color corresponding to the check mark (9).
Note
• If the connection with the camera is not established (when the BUSY lamp is not lit) and no operations are performed for about three minutes,
the PD-10 automatically turns off in order to reduce power consumption.
• If in printing standby (indicated by the check marks in the chart above) for 10 minutes, the PD-10 automatically turns off.
Lamp Display Status Printing standby
POWER Lights Power is on 9
LINK Lights in yellow green Ready for wireless connection 9
Lights in orange Not ready for wireless connection
Blinks rapidly in orange for about 3 seconds There is a problem with the wireless connection.
BUSY Lights in yellow green Printing standby 9
Blinks in yellow green Transferring data for printing
Blinks rapidly in yellow green for about 3 sec-
onds There is a problem transferring data for printing.
Blinks in orange Setting Profile Information on the camera
Lights in orange for about 3 seconds Profile Information setup on the camera complete
Blinks rapidly in orange for about 3 seconds There is a problem setting Profile Information on the camera.
Blinks alternately in orange and yellow green Resetting (c10)