Nilfisk-Advance America Sweeper SR 1700D 2W D - Manual (Page 43)

USER MANUAL
33014815(1)2005-07 A 5
Before handling the machine, the route from where the
vehicle is parked to where the machine is to be installed
should be checked beforehand for any danger areas.
Lift the machine or the boxes as needed to handle the
machine.
PACKING
Packing should be disposed according to the law in force.
INSTALLATION
When delivered, the machine is completely assembled and
perfectly working, so it does not require any installation by the
customer.
GENERAL CHECKS
– Make sure the machine has been inspected before
delivery (check the warranty).
– Check that the machine has not suffered any damage
during transportation and carry out the preliminary
operations for setting the machine at work according to
the instructions in the manual.
– Check the hydraulic system oil level in the tank.
– Check the brake fluid level.
– Check the engine oil level.
– Check radiator coolant level.
– Refuel.
– Start the machine.
– Follow the maintenance instructions.
TECHNICAL DATA
USE
The SR 1700 2WD D sweeper has been designed to perform
a complete cycle of industrial and urban cleaning: sweeping,
waste collecting and dumping.
The sweeping is carried out by one or more side brooms
which convey the debris towards the centre of the machine
and a cylindrical main broom sweeps the collected debris into
the hopper. The dust is collected and controlled by a fan. The
air released into the environment is filtered by a filter. The
waste collected in the hopper may be dumped onto the
ground or into special boxes at a maximum height of 1,510
mm.
MACHINE LAYOUT
(See Fig. E)
1. Fan
2. Side broom
3. Hydraulic system oil tank
4. Steering wheel with power steering
5. Fuel tank
6. Drive hydraulic motor
7. Blower
8. Rear wheel
9. Frame
10. Engine
11. Drive hydraulic pump
12. Main broom hydraulic motor
13. Main broom
14. Accessory hydraulic pump
15. Dust suction filter
16. Hopper
17. Front wheels
18. Side broom hydraulic motor
NOTE
Check that the floor is not too uneven, avoid
driving the vehicle at high speeds, and avoid
excessive swaying of the transported machine.
WARNING!
It is forbidden to get onto the machine, or stand
or walk under it.
NOTE
Any use other than the one described can
damage the machine or injure the operators.