NAD HTR-2 - Manual (Page 6)

COPY A COMMAND FROM ANOTHER KEY
You may copy a command from any HTR 2 key to any other. To copy a
Control key function, after entering the Learning Mode, and pressing the
desired key to be copied to, simply press the device key from which you
wish to copy, having first pressed its Device Selector key if it resides under
another Device key. The status LED will turn green; press the Device Selector
key again to exit Learning Mode.
Example: Copy the pause command from the CD key to the AMP [ || ]
key:
•
On the HTR 2, simultaneously press-and-hold [AMP] and [•] (record);
the Learn LED turns steady green.
• Press [ || ] (pause); the Learn LED turns amber.
• Press [CD]; press [ || ] (pause); the Learn LED turns green.
• Press [AMP] again to exit the learning mode.
NOTE
The copy and punch-through functions are similar. However, if you copy
a command and then subsequently delete, or over-write the original
(source-key) command, the copied-to key’s command remains
unchanged. If you punch-through to a command and then delete or
over-write the original key, the punched-through functions also change
accordingly.
If the source function, and destination function are the same, the HTR-
2 will restore a previously deleted learned command if one exists. So, if
you accidentally deleted a learned command or loaded a library table
over learned commands, this is a quick way to restore them without
having to relearn them.
MACRO COMMANDS
A “macro” command is a series of two or more (up to 64) remote codes
issued automatically from a simple two key-press procedure. You might use
a macro to automate a simple command sequence, such as, “Turn on the
DVD player and then press ‘play.’ Or you might compile an elaborate macro
to power up an entire system, select a source, choose a Listening Mode, and
begin playback-again, all from a single key-press. The HTR 2 can store one
macro on each of its function keys (these exclude the Device Selector keys).
NOTE
Macros are independent of the currently selected device.
RECORDING MACROS
To record a macro, simultaneously press-and-hold for 3 seconds both the
[MACRO] key and the HTR 2 function key to which you wish to assign the
macro; the status LED turns green. The macro button will also light up.
Now, press the sequence of Control function keys to be recorded into the
macro, being sure to first press the requisite Device Selector key for each
function (you may switch devices while recording the macro as many times
as necesarry). This allows you to create a macro containing commands from
more than one Device. When you have finished entering the desired
command sequence, press [MACRO] again to store the macro; the Learn
LED and [MACRO] key illumination will turn off.
NOTE
Each macro can store a maximum of 64 command steps. If you exceed
this number, the macro will be stored automatically after the 64th
command is added.
ENGLISH
FRANÇAIS
DEUTSCH
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA