NordicTrack NTC3015.0 - Manual (Page 7)

7
4. While another person holds the Upright (2) near the
Upright Frame (5), connect the Upper Wire Harness
(42) to the Middle Wire Harness (51). Next, gently
pull the upper end of the Upper Wire Harness to
remove the slack from the Wire Harnesses while
inserting the Upright into the Upright Frame. Be
careful to avoid pinching the Wire Harnesses.
Attach the Upright (2) to the Upright Frame (5) with
two M10 x 97mm Button Screws (77), two M10 Split
Washers (71), and two Curved Spacers (76). Make
sure that the concave end of each Curved Spacer
is facing the Frame. Be careful to avoid damaging
the Wire Harnesses (42, 51).
5. Attach the Left Front Side Shield (13) to the left side of
the Upright Frame (5) with two M4 x 16mm Screws
(57). Attach the Right Front Side Shield (14) to the
right side of the Upright Frame in the same way. Next,
attach the Left Front Side Shield to the Right Front
Side Shield with two M4 x 16mm Screws (57).
5
5 14
57
13
4
51
5
71
77
42
6. Pull the Upper Wire Harness (42) up through the
Handlebar (3) while inserting the Handlebar into the
Upright (2). Be careful to avoid pinching the Upper
Wire Harness.
Attach the Handlebar (3) to the Upright (2) with two
M10 x 97mm Button Screws (77), two M10 Split
Washers (71), two Curved Spacers (76), and two M10
Nylon Locknuts (65). Make sure that the concave
end of each Curved Spacer is turned toward the
Frame. Be careful to avoid damaging the Upper
Wire Harness (42).
Attach the Water Bottle Holder (74) to the Upright (2)
with two M4 x 22mm Screws (60).
3
42
6
57
57
2
71
76
76
2
77
71
76
65
60
74
57
Be careful to
avoid pinching the
Wire Harnesses.
Be careful to
avoid pinching
the Wire
Harness (42).