NEC E750 - Manual (Page 5)

Captive Signal Cable
15-pin mini D-SUB
3
Quick Start
To attach the MultiSync ® E Series monitor to your system, follow
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1 for MultiSync E 750 ™
and Figure A.2 for MultiSync E 950 ™ ). Tighten all screws.
For the Mac: Connect the MultiSync E 750 or MultiSync E 950 Macintosh cable
adapter (not included) to the monitor connector on the Macintosh (Figure B.1).
Attach the 15-pin mini D-SUB end of the captive signal cable to the Macintosh
cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync E 750 or MultiSync E 950 Macintosh cable
adapter, call NEC Technologies at (800) 820-1230.
4. For download information
on the Windows ® 95/98
INF file for your MultiSync
monitor, refer to the
References
section of this
User’s Manual.
5. Connect one end of the
power cord to the
MultiSync E Series monitor
and the other end to the
power outlet (Figure C.1 for
MultiSync E
750 and Figure
C.2 for MultiSync E 950 ).
6. Turn on the monitor (Figure
D.1) and the computer.
NOTE: If you have any
problems, please refer
to the Troubleshooting
section of this User’s
Manual.
Figure A.1
15-pin mini D-SUB
Captive Signal Cable
Figure A.2
MultiSync E 950
MultiSync E 750
78134381.wpc 11/25/98, 2:39 PM 5