Operation – NAD Blu-ray Disc Player T587 User Manual

Page 12

HDMI OUT CONNECTION
• For the 480i/576i resolution setting, the output resolution of HDMI OUT

will change to 480p/576p.

• If you select a resolution manually and then connect the HDMI

jack to TV and your TV does not accept it, the resolution setting will
automatically be set to “Auto”.

• The 1080p video output frame rate may be automatically set to either

24Hz or 60Hz depending upon the capability and preference of the
connected TV and based on the native video frame rate of the BD-ROM
disc’s contents.

• If you select a resolution that is not compatible with your TV, a warning

message as shown below will appear.

After resolution change, if you cannot see the screen, please wait for about
20 seconds and the resolution will automatically revert back to the previous
resolution or a message screen as below may appear

Select “Yes” for the current resolution setting (the VFD will show the
current resolution setting) to be applied. “Current” resolution setting is the
suggested new resolution setting.

Select “No” to seek for the next applicable resolution setting. The above
“Warning” screens will interchangeably be displayed until you select “Yes” to
a suggested resolution setting.

COMPONENT VIDEO OUT CONNECTION
• For the 1080p resolution setting with unprotected media, the

COMPONENT VIDEO OUT resolution will change to 1080i.

• When a protected media is loaded for playback, 720p, 1080i or 1080p

resolution settings of COMPONENT VIDEO OUT will change to either
480i/576i or 480p/576p (depends upon the connectivity of a HDMI
cable - plugged-in or unplugged).

• BD or DVD could prevent up-scaling on analog output.

VIDEO OUT CONNECTION
• The resolution of the VIDEO OUT jack is fixed to 480i/576i.

NOTES
• Depending on your display, some of the resolution settings may result

to abnormal picture or the picture disappearing altogether. When this
happens, press [HOME] key and then toggle [RES] repeatedly until the
picture reappears.

• The T 587 supports simultaneous output of all video out jacks. The

resolution of the HDMI output will not be the same as the resolution on
the Component Video output.

• For a list of applicable resolution settings with respect to video output

port and type of media, please refer to “RESOLUTION SETTINGS” under
the “REFERENCE” main heading.

1080P DISPLAY MODE
Movies shot with film camera consist of 24 frames per second. Since
conventional televisions display frames either at 1/60 or 1/50 second
intervals, the 24 frames do not appear at an even pace. The “24Hz” setting of
the T 587’s “1080p Display Mode” option enables the faithful reproduction
of such film-based materials, displaying each frame at 1/24 second intervals.

24Hz: Using an HDMI-equipped display compatible with 1080/24p
input, set “1080p Display Mode” to “24Hz” for smooth presentation of
film-based materials.
60Hz: If “24Hz” is selected and some picture disturbance is experienced
when the video switches between video and film material, set “1080p
Display Mode” to “60Hz” instead.

NOTE

If your TV is not compatible with 1080/24p, the actual frame frequency
of the video output will be 60Hz even though the “1080p Display Mode”
is set to “24Hz”.

HDMI COLOR SETTING
Set the type of video output from HDMI OUT jack. Select the setting that
matches your display device.

YCbCr: Select when connecting to an HDMI display device.
RGB: Select when connecting to a display device that supports RGB
output.

OPERATION

USING THE T 587

LIS

LIA

РУ

СС