N-Tron 708M12 - Manual (Page 154)

(Revised 2011-07-20) Page 154 of 156
< OtherHex > 0102de03ad00be09ef OtherHex > -- 255*2 character limit -- >
ClientID >
IPConfiguration >
-- ______________________________________________________________________________________ -- >
-- User management -- >
-- A list of logon accounts (5 maximum) to add to the switch. -- >
< Users mode ="keep or delete"> -- mode must be "keep" or "delete" -- >
-- mode=delete - delete existing accounts before adding accounts (default) -- >
-- mode=keep - do not delete existing accounts before adding accounts -- >
-- All User elements (name, password, access) are required. -- >
< User >
< Name > Joe Name > -- 3-15 character limit -- >
< Password > xxx Password > -- 3-15 character limit -- >
< Access > admin OR user Access > -- Access must be admin or user -- >
User >
Users >
-- ______________________________________________________________________________________ -- >
-- Port configuration -- >
-- You may uses this block to define port VLAN identifiers (PVIDs) -- >
< Ports >
< ValidatePorts > yes OR no ValidatePorts > -- optional -- > -- Must be yes(default)
or no. If no, invalid ports are ignored. -- >
-- Use PortNumber or PortName -- >
< Port >
< PortNumber > 4 PortNumber > -- PortNumber ranges from 1 to the maximum port
number for the switch -- >
< PVID > 1 PVID > -- PVID ranges from 1 to 4094 -- >
Port >
< Port >
< PortName > TX6 PortName > -- Name of port on switch -- >
< PVID > 26 PVID > -- PVID ranges from 1 to 4094 -- >
Port >
Ports >
-- ______________________________________________________________________________________ -- >
-- DHCP server -- >
< DHCPServer mode ="keep or delete"> -- mode must be "keep" or "delete" -- >
-- mode=delete - delete existing profiles before adding profiles (default) -- >
-- mode=keep - do not delete existing profiles before adding profiles -- >
< Enabled > yes OR no Enabled > -- Enabled must be yes or no -- >
-- If the server is enabled (enabled=yes), you can add DHCP server profiles.
(If not enabled, can not add profiles.) -- >
< Profile >
-- Required: Name, LowIP, HighIP, LeaseDays. LeaseHours is optional, and
defaults to 0. -- >
< Name > prof1 Name > -- required -- > -- 19 character limit -- >
< LowIP > 192.168.2.1 LowIP > -- required -- >
< HighIP > 192.168.2.254 HighIP > -- required -- >
< LeaseDays > 28 LeaseDays > -- required -- >
< LeaseHours > 0 LeaseHours > -- optional -- >
--The Advanced block is optional, and all elements within the block are
optional.-- >
< Advanced > -- optional -- >
-- All elements below are optional -- >
< BroadcastAddress > 192.168.2.255 BroadcastAddress >