Part identification chart, Assembly – NordicTrack E 200 NTBE1506.0 User Manual

Page 5

M10 Nylon

Locknut (24)

M6 Washer (22)

M10 Washer (23)

M10 x 25mm Bolt (17)

M6 x 50mm Screw (16)

M10 x 90mm Bolt (18)

M10 x 65mm Screw (20)

M10 x 15mm Screw (21)

M10 x 193mm Bolt (19)

PART IDENTIFICATION CHART

See the drawings below to identify small parts used in assembly. The number in parentheses by each drawing is
the key number of the part, from the PART LIST on page 10.

Note: Some small parts may have been pre-

assembled. If a part is not in the parts bag, check to see if it has been preassembled.

Before beginning assembly, carefully read the
following information and instructions:

• Assembly requires two persons.

• Place all parts in a cleared area and remove the

packing materials. Do not dispose of the packing
materials until assembly is completed.

• Tighten all parts as you assemble them, unless

instructed to do otherwise.

• As you assemble the dumbbell bench, make sure

that all parts are oriented as shown in the draw-

ings.

• For help identifying small parts, use the PART

IDENTIFICATION CHART.

In addition to the included hex key and grease
packet, assembly may require the following
tools (not included):

• one standard screwdriver

• one Phillips screwdriver

• one adjustable wrench

• one rubber mallet

ASSEMBLY