ZANKER KBT 23001 SB - Manual (Page 21)

Problem Possible cause Solution
Food placed in the appliance was
too warm Allow food to cool to room temperature
before storing.
Products to be frozen are placed too
closely to each other Place the products in a way so that
cold air could circulate among them
It is too cold inside the freez-
er Temperature Regulator may be set
incorrectly Set a warmer temperature
The appliance does not work
at all. The appliance does not
cool at all. Neither cooling
nor lighting works The appliance may be switched off Switch on the appliance
Plug is not connected to the mains
socket properly Connect the mains plug properly
Power does not reach the appliance Try connecting another electrical de-
vice to the power outlet
There is no voltage in the mains
socket (try to connect another appli-
ance into it) Call an electrician
Replacing the bulb
If you want to replace the bulb, do these steps:
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as shown in
the figure.
4. Replace the bulb with one of the same power and
specifically designed for household appliances
(the maximum power is shown on the light bulb
cover).
5. Fix the lamp cover in place.
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light comes on.
Technical data
Dimension of the recess
Height 1446 mm
Width 560 mm
Depth 550 mm
Rising Time 20 h
Voltage 230-240 V
Frequency 50 Hz
21