Nokia 9650S - Manual (Page 12)

GB 13
Satellite name: From here you can select a name for the configuration.
Switch Type:
There are in principle two kinds of external DiSEqC switches on the market at present. One for
connection of two LNBs. The other one for connection of up to 4 LNBs.
If you have the other switch, defined as DiSEqC, Level 1 or 2 on the market, select “DiSEqC 1, 2, (3
or 4)”, for each LNB connected to respective inputs on this switch.
LNB Type:
Selection is possible for different kinds of LNBs. Select the frequency for the LNB, which is valid for
your combination. You may also enter a value with the numbered buttons on the remote control. The
LNB alternatives are: “Universal” (which is the most common), “5.150”, “9.750”, “10.000”,
“10.050”, ”10.600”, “10.750”, “11.200”, “11.475”.
If you have special LNB type, you should select “User Define” on this menu. And you can enter a new
LNB frequency in the following LNB Frequency menu.
LNB Frequency:
You can enter a special LNB frequency, which is not presented in the LNB Type list as above.
22KHz Tone Switch:
If you have connected to a Dual LNB or two antennas connected to a 22KHz tone switch box, set it to
“Enable” the 22KHz tone switch.
When you have finished the settings in this menu, press the “OK” button to save the parameter.
Press BACK to continue with the channel search set-up
(You can also recall this menu later. From the Main Menu; select “Installation” and then “Antenna
Satellite Configuration”).
Highlight “Automatic Channel Search” using the down arrow
button on the remote control. Mediamaster has pre-
programmed Antenna/Satellite parameters for Astra, HotBird,
Arabsat, NileSat, PanAmsat 4, AsiaSat2, AsiaSat3,
TurkSat1B, TurkSat1C, Thor and Other1 to Other7.
Antenna Alternative: Select the option, “1 to 16”, that
corresponds to your antenna system.
Predefined Channel: Each antenna alternative has one or two pre-programmed channel parameters.
Choose a channel from which you want to start the channel search. Normally, each of the pre-
programmed channels gives the same result.
Search Type: Select “Free Channels” in order to search for free channels only.
Select “All Channels” in order to search all channels on the satellite.
Automatic Channel Search