Nokia 9650S - Manual (Page 11)

GB 12
To install the Mediamaster properly you have to adjust a few
settings. You will always be guided by the information at the
bottom of the menus. When you have finished the final part of
the setup procedure you can start watching TV channels and
listening to radio channels. Now you should have the
“Welcome Menu” on the TV screen. Press the OK button to
proceed.
Select the menu language that you desire. This will define the
language shown in the menus. This will also be the main
language for all the other parts such as audio and subtitling
languages. Press the OK button to proceed.
#"
Installation
In order to configure your equipment (satellite dish and LNB)
you will need to use the following menus.
The LNB is the receiving unit, which is mounted on the satellite
dish. For the following setup procedure you have to know the
Local Oscillator (LO) frequency valid for your LNB(s).
Highlight “Antenna Satellite Configuration” and press the OK
button. You can configure the antenna for each satellite from
this menu.
Antenna Alternative:
Select an Antenna alternative from “1 to 16”. Please note, that
the parameters in the menu are pre-programmed, but you can
change any of them to suit your combination.
The Welcome Menu
Language Settings
Antenna and Satellite Configuration