North Star 10 kW User Manual
Page 35
E
Relay with (normally) closed contact
F Fuse
G NMEA
port
H Power
port
I
Fuse /Breaker board
J and K
Battery
If you want the radar to power ON automatically when the radar processor is powered ON,
omit the relay and leave Pin 10 and 12 on Connector 1 (the NMEA/Comms connector) as No
Connect.
12.8 Connect the 25 kW radar processor to an 8000i display
You are recommended to use the following configuration when connecting the radar processor to an
8000i display, where A is the (optional) NMEA Compass, B is the Circuit breaker/Fuse box, and C is the
vessel's Ground.
Alternative 8000i system configurations are possible. For further information please refer to the
Northstar 8000i System Installation documentation.
Northstar 25 kW Radar Installation Manual
35