NEC MultiSync LCD 1810X - Manual (Page 23)

Appendix
Español
Français
Deutsch
English
Italiano
Installation
Connection to your Personal Computer
The MultiSync LCD 1810X true colour monitor complements PC
compatible computers. Your system has one of two configurations:
– the video controller is built into the computer.
– the video controller is in the form of a display card (sometimes
referred to as graphics card, video adapter or graphics board).
Both configurations have a video connector (or a CRT PORT on laptop
computers). If you are not sure which connector is the video connector,
refer to your computer or display card manual.
To attach the MultiSync LCD 1810X monitor to your system,
follow these instructions:
1. Turn off the power of your computer.
2. For the PC with DVI digital output: Connect the DVI-D to
DVI-D signal cable to the connector of the display card in your
system (Figure A.1). Tighten all screws.
For the PC with DFP digital output: Connect DVI to DFP
Adapter to the computer (Figure A.2).
Attach DVI-D to DVI-D cable to the DVI to DFP Adapter.
Tighten all screws.
For the PC with Analog output: Connect the 15-pin mini D-
SUB to DVI signal cable to the connector of the display card
in your system (Figure A.3).
To connect a secondary PC with analog output, connect the
15-pin mini D-SUB to 15-pin mini D-SUB signal cable (not
include) to the connector of the display card in your system.
For the Mac: Connect the MultiSync Macintosh cable adapter to
the computer (Figure B.1). Attach the 15-pin mini D-SUB signal
cable to the MultiSync Macintosh cable adapter (Figure B.1).
Installation E - 8
CN912B-2/LCD1810X/78135322 00.5.26, 0:03 PM 23