NordicTrack NTBE01100 - Manual (Page 6)

6
6
7
5. Lubricate an M10 x 165mm Bolt (18). Attach the
Right and Left Backrest Frames (3, 4) to the for-
ward tube in the Main Frame (1) with the Bolt, two
M10 Washers (28), and an M10 Nylon Locknut (19).
Do not over tighten the Nylon Locknut; it must
be easy to pivot the Backrest Frames.
Tighten the Screws (16) used in step 4. Tighten
the Nylon Locknuts (19) used in steps 1Ð3.
6. Note that the brackets on the Backrest Frames
(3, 4) have three sets of oval adjustment holes
and one set of round holes.
Position the Spacer (25) between the brackets on
the Backrest Frames (3, 4) and line it up with the
round holes. Insert an M10 x 115mm Bolt (26)
through the round holes in the brackets and through
the Spacer. Secure the Bolt with an M10 Nylon
Locknut (19). Note: The Spacer must be posi-
tioned under the Main Frame (1).
7. Attach the Seat (7) to the brackets on the Main
Frame (1) with four M8 x 16mm Screws (15).
28
18 3
Lubricate
4
1
28
4
3
1
19
5
7
15
1
15
19
25
26