NordicTrack ViewPoint NTL14905.0 - Manual (Page 15)

15
HOW TO TURN ON THE POWER
Plug in the power cord
(see page 13). Next,
locate the reset/off cir-
cuit breaker on the
treadmill frame near
the power cord. Make
sure that the circuit
breaker is in the reset position.
Stand on the foot
rails of the tread-
mill. Find the clip
attached to the key,
and slide the clip
securely onto the
waistband of your
clothes. Next, in-
sert the key into the console. After a moment, the
display will light, and after a few seconds, the tele-
vision will turn on.
Important: In an emergency
situation, the key can be pulled from the con-
sole, causing the walking belt to slow to a
stop. Test the clip by carefully taking a few
steps backward; if the key is not pulled from
the console, adjust the position of the clip.
Note: To prevent damage to the walking platform,
wear clean athletic shoes while using the tread-
mill. The first time the treadmill is used, observe
the alignment of the walking belt, and center the
walking belt if necessary (see page 35).
HOW TO USE THE MAIN MENU
The console’s main menu allows you to view informa-
tion and to enter settings before you begin exercising.
Follow the steps below to use the main menu.
Press the Menu button.
When the Menu button is pressed, the main menu
will appear in the display. The main menu in-
cludes four options: ODOMETER, SELECT
USER, USER SETUP, and TREADMILL SETUP.
To highlight options
within the main menu,
press the up and down
arrow buttons beside
the Menu button.
To view the odometer, see step 2. To designate
yourself as User 1 or User 2, see step 3. To
enter user information, see step 4. To change
console settings, see step 5.
View the Odometer.
Highlight the word ODOMETER in the main menu
and then press the Enter button.
When the Enter button is pressed, the display will
show the total number of miles run by User 1 and
User 2 since the treadmill was purchased. In addi-
tion, the display will show the trip distance—the
distance run during a recent period of time, such
as the most recent month—for User 1 and User 2.
To reset the trip distance, first highlight USER 1 or
USER 2 and press the Enter button. Then, high-
light NO or YES and press the Enter button.
To reselect the main menu, highlight EXIT and
then press the Enter button.
Designate yourself as User 1 or User 2.
The console can keep track of information and
save settings for two different users. Highlight the
words SELECT USER in the main menu and then
press the Enter button.
To identify yourself as User 1 or User 2, highlight
USER 1 or USER 2 and then press the Enter
button.
The console can automatically prompt you to
identify yourself as User 1 or User 2 each time
you insert the key into the console. Highlight the
words SELECT USER in the main menu and then
press the Enter button. Next, highlight USER DIS-
PLAY OPTIONS and press the Enter button. Next,
highlight PROMPT FOR USER and press the
Enter button. Then, highlight NO or YES and
press the Enter button.
The console can also display a welcome message
each time you insert the key into the console.
Highlight SHOW USER WELCOME and press the
Enter button. Then, highlight NO or YES and
press the Enter button.
To reselect the main menu, press the Menu button
twice.
3
2
1
2
1
Key
Reset
Position
Clip