NordicTrack EXP 1000i NTTL09901 - Manual (Page 7)

7. Make sure that all parts are tightened before you use the treadmill. Note: If there is a thin sheet of clear
plastic on the hood decal or the “ComforTrack” decal, remove it. Keep the included allen wrench in a secure
place. The allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet from
damage, place a mat under the treadmill.
6. Insert two Handrail Bushings (75) into the right Upright
(69). Turn the Handrail Bushings so they fit against the
Upright with the thick sides of the Bushings facing the
center of the treadmill, as shown in the inset drawing.
Insert two Handrail Bolts (78) with Handrail Washers
(77) into the Handrail Bushings (75), the right Upright
(69), and the right Handrail Spacer (65). Lift the right
Handrail (66) to align the Bolts with the holes in the
Handrail. Next, thread the Bolts into the Handrail (66).
Do not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Tighten all four Handrail Bolts (78).
6
78 77
75
Thick
Side
69
66
65
75
77
5. Pull the Upright Wire Harness (98) up through the other
Handrail Spacer (65). Place the Handrail Spacer (65) on
the right Upright (69) as shown, with the cutout turned to-
ward the treadmill (see inset drawing A).
Have a second person hold the Handrails (66) near the
Uprights (69) as shown. Connect the Upright Wire
Harness (98) to the wires extending from the Console
Base (81). Insert the connectors and the Wire Harness
into the hole in the Console Base (see inset drawing B).
Being careful not to pinch the Wire Harness (98), set the
Handrails (66) on the Spacers (65).
5
98 69
66
81
65
69
65
81
98
A
B
Cutout
7
4. Slide the Grounding Bracket (116) onto one of the
Handrail Spacers (65) in the location shown.
See inset drawing A. Pinch each of the tabs on the
Grounding Bracket (116) to allow the tabs to fit inside the
hole in the Upright (69) (See inset drawing B).
See inset drawing B. Place the Handrail Spacer (65) on
the left Upright (69) as shown, with the cutout on the indi-
cated side. Note: Make sure that the tabs on the Bracket
are inserted into the hole in the Upright.
4
Tabs
A
B
69
116
116
65
65
Cutout