NetComm NP2724M - Manual (Page 38)

6.4) access-list name set IP-mode packet-type
This command specifies the packet type.
Format access-list name <WORD> set IP-mode packet-type
{ICMP|IGMP|IP|TCP|UDP|GRE}
Mode Global Config
6.5) access-list name set mac-mode
Specify ACL entry priority.
6.5.1) access-list name set mac-mode mac SA
This command specifies a source mac address.
Format access-list name <WORD> set mac-mode mac SA addr>
Mode Global Config
6.5.2) access-list name set mac-mode mac DA
This command specifies a destination mac address.
Format access-list name <WORD> set mac-mode mac DA <mac-
addr> <mask-addr>
Mode Global Config
6.6) access-list name set mac-mode ether-type
This command specifies the ether type of the packet.
Format access-list name <WORD> set mac-mode ether-type
{ipv4|ARP|xns}
Mode Global Config
tacplus
1) tacplus authen_type
This command is used to set authentication type. There are three types for
selecting: local, tacplus, localandtacplus.
Format tacplus authen_type {local | tacplus | localandtacplus}
Mode Global Config
2) tacplus add
This command is used to add a new TACACS+ server and set server IP
address, priority, key string, authentication port and timeout for reply.
Format tacplus add server priority <0-65535> key
port timeout <1-30>
Mode Global Config
3) tacplus del
This command is used to delete a TACACS+ server.
Format tacplus del server
Mode Global Config
2.9.5. Interface Config mode commands
exit
Exit current shell
Format exit
Mode Interface Config
dot1x
Set 802.1x port control.
NP2724M User Manual 37