Niles Audio WS100R - Manual (Page 16)

1. Move the sensor or the sensor cable away from the EMI
source or move the source of the EMI away from the
sensor or the cable.
2. Connect the Sensor’s GND terminal to true earth
ground (if this isn’t feasible use the main system unit’s
GND terminal).
There are many methods for reducing interference. Which
solution is best for you depends on your situation. If you
require further assistance contact Niles Technical Support at
1-800-289-4434.
15
W A L L - M O U N T I N F R A R E D S E N S O R
TECH NOTE
The feedback LED can be disabled if it continues to flicker or
visual feedback is not desired. Discrete on and off IR com-
mands are available on the Niles Technical support website
for disabling the feedback LED. The address is:
nilesaudio.com/techsupport.
DS00331ACN/WS100R 1/8/04 9:47 AM Page 17