Niles Audio WS100R - Manual (Page 10)

Installation
If you ar e installing the WS100R into an existing wall,
take time to consider any possible obstructions which may be
hidden inside the wall, such as wood or metal studs,
electrical, telephone or other types of wiring, plumbing,
AC or heating conduit, etc.
1. Locate the connector plug.
2. Strip 1/4" of insulation from the end of each wire.
3. Use a small flathead screwdriver or your thumbnail to raise
the locking tabs, exposing the holes on the removable
connector plug.
4. Insert each wire into the appropriate hole on the remov-
able connector plug, and snap the locking tab down. To
help you, the connector plug is keyed. Insert the smooth
side of the connector plug into the smooth side of the
socket. Don’t force the scalloped side of the connector
plug into the smooth side of the socket. (Figure 5)
5. Use the shorter plate screws to fasten the Decora cover
plate to the WS100R. DO NOT OVER-TIGHTEN THE PLATE
SCREWS OR YOU MAY DAMAGE THE COVER PLATE. Line
up all the screws in the same direction for a finished look.
9
W A L L - M O U N T I N F R A R E D S E N S O R
“TECH TIP”
Avoid installing the
WS100R next to
a light dimmer.
DS00331ACN/WS100R 1/8/04 9:47 AM Page 11