How to move the hiker, Trouble-shooting – NordicTrack NTHK99900 User Manual

Page 20

How to Move the Hiker

Before moving the hiker, change the grade of the hiker to the lowest level and unplug the power cord.

1. Hold the handrails as shown and place one foot against the

walking belt.

2. Tilt the hiker back until it rolls freely on the wheels. The help

of a second person may be helpful when tipping the hiker.
Carefully move the hiker to the desired location. Never
move the hiker without tipping it back. To reduce the
risk of injury, use extreme caution while moving the
hiker. Do not attempt to move the hiker over an uneven
surface.

3. Place one foot on the walking belt, and carefully lower the

hiker until it is resting on the floor.

Wheels

Trouble-shooting

Most problems can be solved by following the steps below. Find the symptom that applies, and follow the
steps listed. If further assistance is needed, call our Customer Service Department toll-free at 1-888-825-
2588, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor

is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppres-
sor that is UL 1449 listed as a transient voltage surge suppressor (TVSS). The surge suppressor
must have a UL suppressed voltage rating of 400 volts or less and a minimum surge dissipation
of 450 joules. The surge suppressor must be electrically rated for 120 volts AC and 15 amps.
Important: The hiker is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c. Check the circuit breaker located on the hiker near

the power cord. If the switch protrudes as shown, the
circuit breaker has tripped. To reset the circuit
breaker, wait for five minutes and then press the
switch back in.

d. Check the on/off switch located on the hiker near the

power cord. The switch must be in the on position.

Tripped

Reset

Tripped

Reset

Position