Nostalgia Electrics CCP610 - Manual (Page 9)

ENGLISH
7
Assembly of Base Support
Push Handle (E) attaches onto the Concession Stand 1.
(C) using all of the supplied #1 Screws.
Insert Cross Bar (J) into the square inserts on the inside of Base Support (I) 2.
and secure from below with two #2 Bolts and two #4 Flat Washers. Insert
the Leg Assembly (K) over the protruding ends of the Base Support (I) and
fasten four #3 Bolts and four #4 Flat Washers and four #5 Nut Caps.
Assemble Base Support (I) into the bottom of the Concession Stand 3.
(C) and secure with four #2 Bolts and four #4 Flat Washers.