Nostalgia Electrics CCP610 - Manual (Page 10)

ENGLISH
8
Assembly of Wheels
Insert Axle Bolt (F) into Base Support (I). 1.
Put on #5 Flat Washer. Slide Wheel (G) into Axle Bolt (F) 2.
and add a second #4 Flat Washer.
Use Wrench (H) to tighten the #5 Nut Cup. 3.
Add #4 Flat Washer, second Wheel (G), another #4 Flat Washer, and #5 Nut 4.
Cap to the other side of the Axle Bolt (F), following the directions above.
Use Wrench (H) to tighten the #5 Nut Cap. 5.
Assembly of Main Unit
Place Main Unit (A) onto the top of the Concession Stand (C). 1.
Ensure that the two inserting pins at the bottom of the Main 2.
Unit (A) line up correctly so that Main Unit (A) can be locked
under the beam of the Concession Stand (C).
(#5)
Nut
Cap
(#4)
Flat
Washer
(F)
Axle
Bolt
(G)
Wheel
(I)
Base
Support