NordicTrack Incline Trainer NTK1494.1 - Manual (Page 7)

7
2. Insert a Handrail (67) into the Upper Handrail (68) as
shown. The lower end of the Handrail should sit on the
Base Hood (105) as shown. (Note: It may be necessary to
twist the Handrail as you insert it. It may also be neces-
sary to loosen the two 1/2” Screws [63] several turns.)
Next, tighten two 3/4” Screws (66) into the Handrail.
If
you loosened the 1/2” Screws, retighten them.
Attach the other Handrail (not shown) to the left side of
the Incline Trainer in the same way.
68
63
66
67
105
2
3. Interlock the tabs on the Right Outer Cover (88) with the
tabs on the Right Inner Cover (65). Attach the Right Outer
Cover with two 3/4” Bolts (60) as shown
88
65
60
3
4. Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. Insert the threaded end of
the pin through the hole in the Left Outer Cover (61).
Tighten the knob back onto the pin.
Insert the pin into the hole in the Left Inner Cover (106).
Interlock the tabs on the Left Outer Cover (61) with the
tabs on the Left Inner Cover. Attach the Left Outer Cover
with two 3/4” Bolts (60).
Knob
Collar
Spring
Pin
60
106
61
4