Napoleon Grills MIRAGE 485 - Manual (Page 5)

5
LEFT BURNER SIDE BURNER
OPEN LID.
ENSURING BURNER CONTROLS
ARE IN THE OFF POSITION, TURN
ON THE GAS SUPPLY VALVE.
CENTER BURNER
LIGHTING INSTRUCTIONS
RIGHT BURNER
MAIN BURNER LIGHTING SIDE BURNER LIGHTING
1. OPEN SIDE BURNER
COVER.
4. IF THE BURNER WILL NOT IGNITE
WITHIN 5 SECONDS, TURN THE
CONTROL KNOB TO THE ‘OFF’
POSITION AND WAIT 5 MINUTES
FOR ANY EXCESS GAS TO
DISSIPATE. EITHER REPEAT STEPS
2 AND 3 OR LIGHT WITH A MATCH.
3. IF THE BURNER DOES NOT
IGNITE, THEN IMMEDIATELY
TURN THE CONTROL KNOB
BACK TO THE ‘OFF’ POSITION
AND REPEAT STEP 2 SEVERAL
TIMES.
The propane cylinder is equipped with an excess flow device. Unless all burners are
turned off prior to turning the cylinder on, only small flames will be achievable.
1. PUSH AND TURN ANY MAIN
BURNER KNOB SLOWLY TO
THE ’HI’ POSTION. THIS ACTION
WILL IGNITE THE PILOT FLAME
WHICH WILL IN TURN LIGHT THE
SELECTED BURNER. IF THE
PILOT LIGHTS, CONTINUE TO
PUSH DOWN ON THE CONTROL
KNOB UNTIL THE BURNER
LIGHTS AND THEN RELEASE.
2. IF THE PILOT DOES NOT
IGNITE, THEN IMMEDIATELY
TURN THE CONTROL KNOB
BACK TO THE ‘OFF POSITION
AND REPEAT STEP 1 SEVERAL
TIMES.
3. IF THE PILOT AND BURNER WILL
NOT IGNITE WITHIN 5 SECONDS,
TURN THE CONTROL KNOB TO THE
‘OFF’ POSITION AND WAIT 5
MINUTES FOR ANY EXCESS GAS TO
DISSIPATE. EITHER REPEAT STEPS 1
AND 2 OR LIGHT WITH A MATCH.
2. PUSH AND TURN THE
SIDE BURNER CONTROL
KNOB SLOWLY TO THE
‘HI’ POSITION. THIS
ACTION WILL IGNITE
THE SIDE BURNER
If lighting the unit with a match, clip the match into the supplied lighting rod. Hold the
lit match down through the grill and sear plate while turning the corresponding burner
valve to high.