NordicTrack NTC4015.2 - Manual (Page 5)

5
2. While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (16) to the Frame with four
M8 x 50mm Button Screws (52) and four M8 Split
Washers (55).
52
16
1
4
2
Make sure
the Wire
Harnesses
do not get
pinched and
damaged
during this
step.
1
4. While another person holds the Upright (2) near the
Frame (1), connect the Upper Wire Harness (42) to the
Lower Wire Harness (43). Next, carefully pull the Upper
Wire Harness up through the Upright while inserting
the Upright into the Frame. Attach the Upright with an
M10 x 63mm Bolt Set (62). Be careful to avoid pinch-
ing the Wire Harnesses (42, 43).
Attach the Water Bottle Holder (74) to the Upright (2)
with two M4 x 22mm Screws (60).
2
52
55 55
62
43
62
60
74
42
3
7
1
3. Turn the Adjustment Knob (7) into the Frame (1).
5. The Console (4) requires four “D” batteries (not includ-
ed); alkaline batteries are recommended. Remove the
battery cover from the bottom of the Console. Next,
insert four batteries into the battery compartment;
make sure that the batteries are oriented as shown
by the diagram inside the battery compartment.
Reattach the battery cover.
5
4
Batteries
Battery
Cover