Niles Audio HDLCR - Manual (Page 17)

NILES AUDIO CORPORATION – 1-800-BUY-HIFI
2. Screw one side of the assembled bracket with wings to the stud or joist, using one
of the supplied screws. Level the bracket, and then screw the other side of the
bracket/wing assembly to the stud or joist. Two screws on each side make for a
very secure installation.
3. Attach the wire to the bracket at the indicated
wire tie points, as shown in Figure 10.
CONCEALING SPEAKER WIRE FOR
A FUTURE INSTALLATION
1. Attach the speaker wire in a loop between the
ceiling joists and carefully mark the
exact location of the wire on a set of plans.
2. Ask the general contractor to inform the drywall
installers that the speaker wire loops are
concealed for future installations, as shown in
Figure 11.
4 Wire Ties
15
Figure 10. The hole-saving brackets with QuickSnap new-construction wings can be installed
horizontally or vertically.
Figure 11. The speaker wire
is looped and hung on two nails
attached to the joists, securing it
for future use. Be sure to note the
location on house plans.