NETGEAR ADSL Modem Router - Manual (Page 6)

ADSL Modem Router Setup Manual
1-2 Connecting the Router to the Internet
v1.1, 2006-2
The Router’s Front Panel
The ADSL modem router front panel shown below contains status LEDs.
You can use the LEDs to verify various conditions. Table 1-1 describes each LED.
Figure 1-1
Table 1-1. LED Descriptions
Label Activity Description
1. Power
On
Off Power is supplied to the router.
Power is not supplied to the router.
2. Test
On
Off The system is initializing.
The system is ready and running.
3. Internet
Blink -- Amber
On -- Green
Blink -- Green Indicates ADSL training.
The Internet port has detected a link with an attached device.
Data is being transmitted or received by the Internet port.
4. LAN
On (Green)
Blink (Green)
On (Amber)
Blink (Amber)
Off The Local port has detected a link with a 100 Mbps device.
Data is being transmitted or received at 100 Mbps.
The Local port has detected a link with a 10 Mbps device.
Data is being transmitted or received at 10 Mbps.
No link is detected on this port.
1
2 3 4