New Media Technology IP Power 9212 - Manual (Page 17)

Click the test-itself button and you will see the figure above. The states of OUT1, OUT2, OUT3 and
OUT4 will separately keep in ON for 1 second, 3 seconds, 6 seconds and 8 seconds, then all back to
OFF. After one period, four outputs will keep in OFF state for the same time. This process will repeat
until you click the reset or cancel button.
2. Set the output’s state to ON/OFF
Click the output you want to change,
set it to ON or OFF state and click apply
button to finish the setting.
3. Set one output be in ON/OFF state
at the appointed time
You can set the state when one output
starts, either ON or OFF. You can also set
the delay time and the action when the
delay time is up. Then click apply button to
confirm it. The example shows in the figure
above means the OUT3 will be in ON state
when it starts and will changes the state to
OFF after 30 seconds.
4. Reset the ON/OFF settings
Click the reset button you can cancel the previously output settings.
- 16 -