beautypg.com

Niles Audio RCA3 User Manual

Page 8

background image

8

R

E

M

O

T

E

C

O

N

T

R

O

L

A

N

Y

W

H

E

R

E

!

K

I

T

Step 4 – Mounting a MicroFlasher to A/V Components
Make sure all of your remote controls have batteries and that
they are able to operate the A/V components.

Locate a place for the remote control that is within arm’s
length of the A/V components, yet cannot directly control
them. Place the table-top sensor no closer than two feet in
front of the remote control (

Figure 6).

Hold the MicroFlasher four inches
in front of the remote sensor
window on the A/V compo-
nent’s front panel. Press but-
tons on the remote control
while watching the front
panel of the A/V compo-
nent. When the compo-
nent responds repeatedly
to the commands, peel off
the protective backing on
the MicroFlasher and place
the MicroFlasher in that
location.

If the A/V component’s
remote sensor is not clearly
marked, slowly move the
MicroFlasher over the win-
dow of the A/V component
while pushing buttons on
the remote control until you
get a response (

Figure 7).

Figure 6:
Locating IR Sensor

DS00408ACN_RCA3 Kit.qxp 1/17/05 3:52 PM Page 8