NordicTrack APEX6100 NTTL24992 - Manual (Page 6)

ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
2. With the help of a second person, carefully raise the
Frame (7) to the storage position and make sure that
the lock pin is properly engaged as described on page
25.
Position the Base Plate (115) on the treadmill as shown.
Attach the Base Plate with the three Base Plate Screws
(114). Note: It may be helpful if a second person tips
the treadmill slightly as you tighten the Screws.
Carefully lower the Frame (7) to the floor as described
on page 25.
115
7
114
2
3. Place one of the Handrail Spacers (92) on the right
Upright (83) as shown, with the cutout on the indicated
side (see inset drawing A). Pull the Upright Wire Harness
(131) up through the cutout. Place the other Handrail
Spacer on the left Upright (not shown).
Have a second person hold the Handrails (73) near the
Uprights (83) as shown. Connect the Upright Wire
Harness (131) to the wires extending from the right
Handrail. Insert the connectors and the Upright Wire
Harness (131) into the opening in the Console Base (79)
(see inset drawing B).
Set the Handrails (73) on the Handrail Spacers (92),
being careful not to pinch the Wire Harness (131).
131
83
73
79
92
92
79
A
B
Cutout
3
6
131
1. With the help of a second person, carefully raise both
Uprights (83) to a vertical position. Make sure that the
Lock Knob Sleeve (87) is in the left Upright.
Next, make sure that the Lock Pin Collar (89) and the
Spring (88) are on the Lock Pin (91). Insert the Lock Pin
into the Lock Knob Sleeve (87) and the Left Upright (83).
Press the Lock Knob Spacer (86) onto the left Upright
(83). Tighten the Lock Knob (85) onto the Lock Pin (91).
83
86
87
85
88
89
91
1