Fig. 3 – Newcon Optik LRB 7x50 User Manual

Page 9

b. Mode selection state

Pressing MODE button (5) (fig. 1) when the System is in
READY mode brings the System to the Mode selecting state.
Pressing the Mode button can sequentially scan the Modes. The
Mode under selection is being indicated on the Display by
flashing of the selectable feature. The "flashing" feature can be
selected by pressing the Action button (6).

The System operates in the setting Modes, which are displayed
as follows (refer to fig.3):

Y/M – units of measurement: yards or meters (3).

KMH/MPH – units of speed measurement: km/hour or
miles/hour (3). Please note: this is an optional feature.

Shape of the reticule: cross shape or rectangular shape (2).
Please note: this is an optional feature.

rEC1 - recall function. Upon pressing the Action button (6)
(fig. 1) the Display will sequentially show results of last 10
measurements, starting from the latest one. The number
appearing after word "rEC" shows the number of the
measurement counted back in the sequence. When the System is
in inactive state the 10 previous measurements are stored within
the System and may be recalled any time;

5. OPERATION INSTRUCTIONS

Liquid Crystal Display (LCD)

1 – Low Battery Indicator; 2 – Reticule (cross or rectangular

selectable); 3 – Units of Measurement (Yards, Meters, KMH,

MPH or Degrees); 4 – Measurement Result;

5 – Target Quality Indicator (optional); 6 – Laser Active Indicator

7 – Over 100m Indicator (optional).

Fig. 3