NorthStar Navigation EXPLORER 657 - Manual (Page 65)

65 Northstar Explorer 657 Installation and Operation Manual
Press twice, then select Sonar:
Frequency
There is a choice of: 200 kHz, 50 kHz and
Mixed. For information about selecting a
suitable frequency for the water conditions. (see
section 8-3)
Scroll speed
Use this to set the scroll speed on the display.
There is a choice of: Very Fast, Fast,
Medium, Slow and Pause. The depth of the
water also affects the speed of the display.
Faster scroll speeds combined with a slow
boat speed (typically between 2 and 6 knots)
shows the most fish detail. Medium or Slow
scroll speeds result in sonar information being
displayed over a longer period, but with less
detail (see Section 8-2).
Fish symbols
The 657 always displays echoes from fish (fish
arches, see section 8-4). If fish symbols are on, a
symbol is displayed over the arch (see section
8-4). The options are:
• Off: No fish symbol is displayed.
• Fun or Normal: A fish symbol is displayed.
• Fun + depth or Normal + depth: A
fish symbol is displayed and the depth shown
beside the fish symbol.
Fish filter
Use this to select the minimum fish size that will
be displayed as a fish symbol and to trigger the
Fish alarm. The options are: Small, Medium
and Large.
17-3 Setup > Sonar
Fish sensitivity
Selects the minimum strength fish echo that will
be displayed as a fish symbol. Higher values will
display more fish symbols.
Digit size
Use this to remove or change the size of the
depth window on the sonar displays. There is a
choice of: Small, Medium and Large.
Palette
Use this to select a color palette. Each color
within the palette represents a different echo
strength, as shown on the sonar displays.
There is a choice of five color palettes: Black,
Blue, White, Vivid and 8 color. The first
four pallettes display more detail, and each color
covers a 1.5 dB signal range. The 8 color
palette displays less detail, and each color covers
a 3 dB signal range.
Interference filter
No filter, normal setting.
Filters the echo signal to remove spiky
interference such as engine noise or depth
sounders on nearby boats.
Noise filter
Averages the echo signal to remove rapid
changes. Select Meduim or High to give a
smoother bottom trace–this may help to detect
a deeper bottom; however these settings may
also remove fish echoes. Select Off for best
fishfinding.
Pulse length
This can be used to specify the length of the
transmitted ultrasonic pulse. A short pulse length
improves the display detail but contains less
energy, therefore it does not penetrate as deeply
into the water as a longer pulse.
There is a choice of Auto, Short, Medium or
Long. The Auto setting is recommended.
Pulse power
This can be used to specify the power output
of the transmitted ultrasonic pulse. Low power
output conserves the battery and produces a
clear display in shallow water.
There is a choice of Auto, Low, Medium or
High. The Auto setting is recommended.