Newcon Optik NSN: 5855-20-000-8284 NVS 7 User Manual
Page 17
14
FIGURE 7
1.
locking screw
2.
flip/flop button
3.
flip-flop adjusting screws
4.
mount binding screw
1 2
3
4
Using helmet mount
The unit can be equipped with an optional helmet mount.
This mount can be customized to fit a variety of existing
helmet models.
The mount is attached to a helmet with straps.
The unit is fixed to the mount by a locking screw (1, Fig.
7). To adjust the position of the unit to your eye level use
the screw (4, Fig. 7). To adjust the eye relief first loosen
locking screw (1, Fig. 7) and set a comfortable distance
between the eyes and the eyepiece; then tighten the
locking screw back.
You can fixate the unit in three predetermined positions: vertical,
horizontal, and 15-20 degrees above horizontal. Although the
relative angles between these positions cannot be changed, the