NAD SYSTEM REMOTE CONTROL S70 - Manual (Page 16)

16
GB
TROUBLESHOOTING GUIDE
Remote control works
intermittently or doesn’t
work at all • Battery flat or snap-on
connector incorrectly
attached
• IR transmitter or receiver
windows obstructed
• IR receiver on components
are in direct sun or very
bright ambient light
• Check or replace battery
• Remove obstruction
• Place unit away from
direct sun, reduce amount
of ambient light
Problem Cause Solution
Sleep Timer and Timer
functions can’t be activated • These functions are
available only if clock is
activated
• Activate clock
Although activated, Sleep
Timer and Timer function do
not work properly or at all • IR transmitter or receiver
windows obstructed
• IR receiver on components
are in direct sun or very
bright ambient light
• Remove obstruction
• Place unit away from
direct sun, reduce amount
of ambient light
Display is difficult to read • Too little or too much
contrast
• Battery almost flat
• Adjust display’s contrast
level
• Replace battery
Sometimes not all
components respond to
On/Off command, causing
these to be "out-of-sync" for
stand-by/operating status • Remote control is just out
of range
• Reduce operating distance
• Connect NAD-Link
between components